Phaser 6180MFP Multifunction Printer Service Manual A-3ReferenceFirmware UpdateNoteThe firmware update procedure in this manual is for PC only. It isimportant to perform Firmware Update procedures in the following order.1. “Firmware MPC Update” on page 8 (if an MPC is installed on the printer)2. “Control Panel Bit Map Display Update” on page 33. “Boot Controller Update” on page 54. “Firmware Controller Update” on page 6Control Panel Bit Map Display Update1. Download applicable files from the Xerox support web site. Unzip(decompress) the files.2. Be sure the appropriate downloading option (Network, USB, or Parallel) isavailable and connected.3. Reboot the printer.4. On your computer, locate the decompressed files. Open the Paneldirectory. Double-click the Xeroxfwup.exe file.5. The xeroxfwup window with connection options is displayed. Threeconnections are available for updating the Control Panel Bit Map Display.a. For Network connection:■ Select Network and click the Next button.■ If your printer’s IP address is available, select the appropriate box.Click the Next button.■ If your printer’s IP address is not listed, click the Add button.Enter your printer’s IP address and click the OK button. Select thebox with your printer’s IP address and click the Next button.■ On the printer’s Control Panel, messages are displayed fromReceiving data Port 9100 --> Please wait... Port 9100 F/W -->Writing... Port 9100 AIOC --> Writing... Port 9100 PANEL asthe printer starts updating the firmware.b. For USB connection:■ Select USB and click the Next button.■ Select the box with the printer to be updated and click the Nextbutton.■ On the printer’s Control Panel, messages are displayed fromReceiving data USB... AIOC --> Please wait... USB F/W -->Writing... USB AIOC --> Writing... USB PANEL as the printerstarts updating the firmware.
