Phaser 6180MFP Multifunction Printer Service Manual 3-99Error Messages and CodesOut of Memory/Hard Drive FullThe printer memory is full and cannot continue to print. Print job requiresadditional memory. The following troubleshooting procedure applies to theseerrors.Applicable Chain Link■ Chain Link 016-718: Out of memory■ Chain Link 016-982: Hard Drive Full (Disk Full)Initial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Image Processor Board, PL9.1.20■ Memory Card (Option), PL9.1.22Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the required memory for theprint job.2. Print a small size file (example as aWindows test print).3. Does the error still occur?Go to step 2. Add memorycard or separatethe print job.2 1. Reseat the memory card(page 8-94).2. Does the error still occur?Go to step 3. Complete.3 1. Check the memory card capacity.Print the printer Configuration Page:System > Information Pages >Configuration.2. Does the memory meet the print jobrequirements?Go to step 4. Replace theImageProcessorBoard(page 8-90).4 1. Replace the memory card(page 8-94).2. Does the error still occur?Replace theImageProcessor Board(page 8-90).Complete.
