3-134 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesDeve Motor ErrorThe Deve Motor has failed. The following troubleshooting procedure applies tothis error.Applicable Chain Link■ Chain Link 093-320: Deve Motor Error (IOT Motor Failure)Initial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Feeder Kit, PL3.2.1■ Main Drive, PL8.1.2■ MCU Board, PL9.2.13■ Right Side Harness, PL10.1.12■ “Map 1 - Electrical and Drive” onpage 10-10■ “Map 4 - LVPS and MCU Board” onpage 10-13■ “Main Drive” on page 10-28Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the Print Cartridges forcorrect installation.2. Are the Print Cartridges correctlyinstalled?Go to step 3. Reseat the PrintCartridges(page 8-11).Go to step 2.2 Does the error still occur when theprinter is turned On?Go to step 3. Complete.3 1. Check the wiring harnessconnectors P/J22 and P/J222between the MCU Board and theMain Drive.2. Are the connectors securelyconnected?Go to step 4. Reconnect theconnectors.Go to step 4.4 1. Perform the Deve Motor test(page 4-57): Service Mode >Printer Diag > Engine Diag > MotorTest > Deve Motor. Close the FrontDoor while running the test.2. Does the Motor operate properly?Replace theMCU Board(page 8-88).Go to step 5.
