4-112 Phaser 6180MFP Multifunction Printer Service ManualGeneral TroubleshootingUNIX / LinuxThis section includes:■ Quick Install Steps■ Additional ResourcesYour printer supports connection to a variety of UNIX platforms through theParallel and Network interface. The workstations currently supported byCentreWare for UNIX/Linux to a network-connected printer are:■ Sun Solaris■ IBM AIX■ Hewlett-Packard HP-UX■ Linux (i386) tested on SUSE 10.0, RedHat 9, Fedora Core1The following procedures enable you to connect your printer using any of thesupported versions of UNIX or Linux listed above.Quick Install StepsPerform the following procedures to set up the printer and install theappropriate drivers.From the PrinterTo set up the printer:1. Verify that both TCP/IP protocol and the proper connector are enabled.2. On the Control Panel, select one of these IP address options:■ Allow the printer to set up a DHCP address■ Enter the IP address manually3. Print the Configuration page and keep it for reference.From Your ComputerTo install the CentreWare for Unix driver:1. Go to www.xerox.com/office/6180MFPdrivers.2. Select your printer, the platform your are running (UNIX), and file type(Drivers).3. Click Go to Downloads.4. From the list of provided files, download the PrinterPackageXPXX andthe appropriate CentreWare printer driver for your platform XPXX4.xx.x.tar.a. As root untar the Driver and Printer package, this will create twosubdirectories. Cd to InstallPackage and type ./setup to installthe driver.b. CD to the PrinterPackagexpxx and type ./setup to install the printerspecific data files.
