3-84 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesLoad Tray 3 (No Suitable Paper)The type or size of paper mismatched or Tray 3 is empty. The followingtroubleshooting procedure applies to this error.Applicable Chain Link■ Chain Link 024-960: Load Tray 3 (No Suitable Paper)Initial Actions■ Inspect the tray to ensure that it is free of obstructions, is loaded withsupported paper, and the Guides are adjusted correctly.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Feeder Unit, PL3.2.1■ Registration Sensor, PL3.2.30■ Registration Sensor Harness,PL3.2.37■ No Paper Actuator, PL3.2.49■ MCU Board, PL9.2.13■ Right Side Harness, PL10.1.12■ 550-Sheet Feeder, PL13.1.1■ Tray 3 Feeder, PL13.2.8■ Tray 3 Feeder Harness, PL13.3.3■ Tray 3, PL13.4.1■ “Map 1 - Electrical and Drive” onpage 10-10■ “Map 2 - Laser Unit and Feeder” onpage 10-11■ “Map 4 - LVPS and MCU Board” onpage 10-13■ “Feeder” on page 10-30■ “Tray 1 (MPT) and Registration” onpage 10-26■ “Optional 550-Sheet Feeder WiringDiagram” on page 10-45Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the paper size.2. Does the paper size meetspecifications?Go to step 2. Replace thepaper with thecorrectspecifications.2 1. Check the paper size setting.2. Does the paper match with thesettings in the Control Panel?Go to step 3. Correct thepaper settingsin the ControlPanel.Go to step 3.
