Phaser 6180MFP Multifunction Printer Service Manual 6-11Adjustments and CalibrationsPrinter Parameter SettingThis function reads/writes the parameter values, errors, and life countervalues stored in the printer.NotePrint the parameter list from the Service Diagnostics menu - ServiceMode > Printer Diag > Parameter > Print before changing theregistration value.To access the Parameter menu:1. Turn the printer power Off (if the printer is On).2. Simultaneously press the Up Arrow and Down Arrow buttons and turnon the printer.3. The Service Mode menu is displayed.4. Select Printer Diag and press the OK button.5. Press the Up Arrow or Down Arrow button to find Parameter. Press theOK button.6. Press the Up Arrow or Down Arrow button to find the appropriate item tochange (i.e., Slow Scan KtoP). Press the OK button.7. Enter the appropriate range using the Up Arrow or Down Arrow button.Press the OK button to save the value.8. The new value “# *” is displayed. The Parameter menu is displayed.9. Press the Exit button to return to the Printer Diag menu. Press the UpArrow or Down Arrow button to find Exit Mode. Press the OK button.10. Complete Exit message is displayed. Press the OK button.11. Exit? message is displayed. Press the OK button.12. Please wait... --> Ready messages are displayed on the printer ControlPanel.Note“*” = data has been saved
