Xerox Phaser 6180MFP Service Manual

Also see for Phaser 6180MFP: Brochure & specs User guide Features setup guide Supplementary guide Supplementary guide

Contents

Xerox Phaser 6180MFP Service Manual Manual pdf 693 page image

Phaser 6180MFP Multifunction Printer Service Manual 8-75Service Parts DisassemblyDriveMain Drive Assembly (PL8.1.2)1. Open the Front Cover.2. Remove the Fuser (page 8-12).3. Remove the Rear Cover (page 8-18).4. Remove the Bottom Cover (page 8-19).5. Remove the Right Pole Inner Cover (page 8-21).6. Remove the Right Pole Cover (page 8-22).7. Remove the Right Cover (page 8-23).8. Remove the Left Pole Inner Cover (page 8-24).9. Remove the Left Pole Cover (page 8-25).10. Remove the Left Cover (page 8-26).11. Remove the Top Cover (page 8-27).NoteWhen performing the following step, it is not necessary to disconnect theInterlock Switch.12. Remove the Interlock Switch (page 8-82).13. Remove 2 screws (10 mm) securing the Fuser Bracket (PL6.1.12) to theprinter.CautionDO NOT separate the Fuser Bracket and the printer too far apart,because they are connected by a wiring harness.14. Remove the Fuser Bracket.15. Release the Main Drive wiring harness from the Main Drive Duct(PL8.1.9).16. Remove 1 screw (10 mm) securing the Main Drive Duct to the printer.17. Release the notches on the Main Drive Duct and slide the Main DriveDuct backward to remove it.18. Disconnect the following 4 connectors:■ Main Motor - P/J211■ Sub Motor - P/J221■ Developer Motor - P/J222■ Exit Clutch: P/J2761