Xerox Phaser 6180MFP Service Manual

Also see for Phaser 6180MFP: Brochure & specs User guide Features setup guide Supplementary guide Supplementary guide

Contents

Xerox Phaser 6180MFP Service Manual Manual pdf 360 page image

3-172 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesNetwork Not Ready, Scan Aborted ErrorThe scan job has been aborted due to network not ready. The followingtroubleshooting procedure applies to this error.Applicable Chain Link■ Chain Link 016-794: Network Not Ready, Scan Aborted Error (SMB OverTCP Error)Initial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Image Processor Board, PL9.1.20Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the network setting using aPC.2. Is the setting correct?Go to step 2. Set the correctnetworkinformation.2 1. Check the network setting: System >Admin Menu > Network Settings.2. Is the printer network settingcorrect?Go to step 3. Set the correctnetworksettings.3 1. Check the Protocol setting: System> Admin Menu > Network Settings> Protocol > SMB TCP/IP?2. Is SMB TCP/IP disabled?Set SMB TCP/I/P to Enable.Go to step 4.4 1. Check the Image Processor Boardfor correct installation. Reseat theImage Processor Board(page 8-90).2. Does the error still occur when theprinter power is turned On?Replace theImageProcessor Board(page 8-90).Complete.