1-28 Phaser 6180MFP Multifunction Printer Service ManualGeneral InformationWarm-Up TimeWarm-up Time is defined as the time when the printer changes from Power-On to Standby mode.■ Standard Configuration: 30 seconds or less■ Environmental Temperature: 22° C (72° F)■ Humidity: 55% RHFirst Print Output TimeFirst Print Output Time (FPOT) is defined as the time from when the enginereceives a Start signal in Ready state, until a single page is printed anddelivered to the output tray.The following conditions are applied:■ The Controller does not keep the print engine waiting.■ The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).■ Paper is A size Short-Edge Feed (SEF).■ Process control time is not included.First Copy Output TimeFirst Copy Output Time (FCOT) is defined as the time slot when the Startbutton is pressed until the trail edge of the first copied media passes theprinter Exit Roller.The following conditions are applied:■ The Controller does not keep the print engine waiting.■ The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).■ Paper is A size Short-Edge Feed (SEF).■ Document is on the document glass (Document setting: Platen mode).■ Media: Media feed from the standard media tray.Mode FPOT (sec.)Color As fast as 10.0Mono As fast as 10.0Mode FCOT (sec.)Color As fast as 11.1Mono As fast as 20.0
