3-46 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesConsumable/Routine Maintenance ErrorsInsert FuserThe printer does not detect the presence of the Fuser. The followingtroubleshooting procedure applies to this error.WarningThe Fuser may be hot. Turn the printer power Off and allow at least 5minutes for the Fuser to cool before removing the Fuser.Applicable Chain Link■ Chain Link 010-317: Insert Fuser (IOT Fuser Detached)Initial Actions■ Ensure that the Fuser latches are fully locked.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map Reference■ Fuser, PL6.1.10■ MCU Board, PL9.2.13■ LVPS, PL9.2.14■ LVPS Harness, PL10.1.3■ Fuser Harness, PL10.1.5■ “Map 1 - Electrical and Drive” onpage 10-10■ “Map 4 - LVPS and MCU Board” onpage 10-13■ “Fuser” on page 10-40Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the Fuser for correctinstallation.2. Is the Fuser correctly installed?Go to step 2. Reseat theFuser(page 8-12).Go to step 2.2 Does the error still occur when theprinter is turned On?Go to step 3. Complete.3 1. Check the wiring harnessconnectors P/J17, P/J171, P/J47, P/J501, and P/J14 between the MCUBoard and the Fuser Unit.2. Are the connectors securelyconnected?Go to step 4. Reconnect theconnectors.
