3-170 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesNetwork Not Ready ErrorThe network is not ready. The following troubleshooting procedure applies tothis error.Applicable Chain Link■ Chain Link 016-790: Network Not Ready Error (F2N Module is notReady)Initial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Scanner Controller Board, PL9.1.1■ Image Processor Board, PL9.1.20■ Multi-Protocol Card, PL9.1.23Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the network connection usingping command.2. Does the printer connect to thenetwork?Go to step 2. Go to step 5.2 1. Check the Address Book setting:System > Admin Menu > AddressBook > Speed Dial/Group Dial.2. Is the Address Book setting correct?Go to step 3. Set the correctAddress Bookinformation.3 1. Check the printer specification.2. Does the printer specification meetthe server specification?Go to step 4. Change theserver.4 1. Check the Scanner Controller Boardfor correct installation. Reseat theScanner Controller Board(page 8-99).2. Does the error still occur whenconnecting to the server?Replace theScannerController Board(page 8-99).Complete.5 1. Check the network connection.Reseat the network connector.2. Does the error still occur?Go to step 6.If an MPC Cardis not installed,go to step 7.Complete.
