Xerox Phaser 6180MFP Service Manual

Also see for Phaser 6180MFP: Brochure & specs User guide Features setup guide Supplementary guide Supplementary guide

Contents

Xerox Phaser 6180MFP Service Manual Manual pdf 236 page image

3-48 Phaser 6180MFP Multifunction Printer Service ManualError Messages and CodesFuser Error (IOT Fuser Life Over)The Fuser has reached its end of life. The following troubleshooting procedureapplies to this error.WarningThe Fuser may be hot. Turn the printer power Off and allow at least 5minutes for the Fuser to cool before removing the Fuser.Applicable Chain Link■ Chain Link 010-351: Fuser Error (IOT Fuser Life Over)Initial Action■ Check the Fuser life using CentreWare IS.■ Cycle printer power.■ If problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Fuser, PL6.1.10■ MCU Board, PL9.2.13■ “Map 1 - Electrical and Drive” onpage 10-10■ “Map 4 - LVPS and MCU Board” onpage 10-13■ “Fuser” on page 10-40Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the Fuser life using CentreWare IS.2. Does the Level show 0%?Replace theFuser(page 8-12).Go to step 2.2 Is the Fuser correctly installed? Go to step 3. Reseat theFuser(page 8-12).3 Does the error still occur when the power isturned On?Go to step 4. Complete.4 1. Replace the Fuser (page 8-12).2. Does the error still occur?Replace theMCU Board(page 8-88).Complete.