Phaser 6180MFP Multifunction Printer Service Manual 3-183Error Messages and CodesControl Panel ErrorThe parameter setting on the Control Panel has failed. The followingtroubleshooting procedure applies to these errors.Applicable Chain Link■ Chain Link 062-323: Panel Setting Parameter NG■ Chain Link 123-314: Control Panel ErrorInitial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Control Panel, PL1.2.2■ Scanner Controller Board, PL9.1.1■ “Map 1 - Electrical and Drive” onpage 10-10■ “Automatic Document Feeder WiringDiagram” on page 10-53Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Wait for 5 seconds and turn theprinter Off and back On.2. Does the error still occur when theprinter is turned On?Go to step 2. Complete.2 1. Check the Scanner Controller Boardfor correct installation. Reseat theScanner Controller Board(page 8-99).2. Does the error still occur when theprinter is turned On?Go to step 3. Complete.3 1. Check the Control Panel for correctinstallation. Reseat the ControlPanel (page 8-30).2. Does the error still occur when theprinter is turned On?Go to step 4. Complete.4 1. Replace the Scanner ControllerBoard (page 8-99).2. Does the error still occur when theprinter is turned On?Replace theControl Panel(page 8-30).Complete.
