Phaser 6180MFP Multifunction Printer Service Manual 6-7Adjustments and CalibrationsSaving NVM (NVRAM)This process saves the settings stored in the NVRAM to the Image ProcessorBoard.1. Access the Service Diagnostics menu by pressing and holding the Upand Down Arrow buttons simultaneously and turn the printer power On.2. The Service Mode is displayed. Select Printer Diag and press the OKbutton.3. Press the Up Arrow or Down Arrow button to find Engine Diag. Pressthe OK button.4. Press the Up Arrow or Down Arrow button to find NVM Settings. Pressthe OK button.5. Press the Up Arrow or Down Arrow button to find Save NVM to ESS.Press the OK button.6. SaveNVM to ESS - OK? message is displayed. Press the OK button tostart the process.7. Processing > Saved message is displayed.8. Press the Exit button three times to return to the Printer Diag menu.Press the Up Arrow or Down Arrow button to find Exit Mode. Press theOK button.9. Complete Exit message is displayed. Press the OK button.10. Exit? message is displayed. Press the OK button.Loading NVM (NVRAM)This process loads the NVM settings stored in the Image Processor Board.1. Access the Service Diagnostics menu by pressing and holding the Upand Down Arrow buttons simultaneously and turn the printer power On.2. The Service Mode is displayed. Select Printer Diag and press the OKbutton.3. Press the Up Arrow or Down Arrow button to find Engine Diag. Pressthe OK button.4. Press the Up Arrow or Down Arrow button to find NVM Settings. Pressthe OK button.5. Press the Up Arrow or Down Arrow button to find LoadNVM from ESS.Press the OK button.6. LoadNVM from ESS - OK? message is displayed. Press the OK buttonto start the process.7. Processing > Loaded message is displayed.8. Press the Exit button.9. Please wait... message is displayed on the printer’s Control Panel.10. NVM Settings... - LoadNVM from ESS menu is displayed.11. Press the Exit button two times to return to the Printer Diag menu. Pressthe Up Arrow or Down Arrow button to find Exit Mode. Press the OKbutton.12. Complete Exit message is displayed. Press the OK button.13. Exit? message is displayed. Press the OK button.14. Please wait... --> Ready messages are displayed on the printer ControlPanel.
