Chapter 22-35F-2-1442.2.22 Adjusting the Horizontal Registration 0012-2060iR7095P1) Press the release button of cassette 3/4, and slide out the cassette.2) Detach the cassette front cover [1] in the direction of the arrow.- 2 screws [2]F-2-1453) Loosen the 2 fixing screws [1] found on the right/left of the cassette.4) Move the cassette case [2] to the front or the rear to make adjustments.- move it to the rear to decrease the horizontal registration (left margin).- move it to the front to increase the horizontal registration (left margin).F-2-1465) Check to make sure that the horizontal registration (left margin) on printsusing cassette 3/4 as the source of paper is 2.5 +/-1.5 mm.F-2-147[1] Paper movement6) When done, tighten the 2 fixing screws loosened in step 3).7) Shift up the cassette front cover [1] in the direction of the arrow, and se-cure it in place using 2 screws [2].F-2-1488) Put cassette 3/4 back inside the machine.9) When done, execute the following service mode items:Cassette 3COPIER > FUNCTION > CST > C3-STMTRCOPIER > FUNCTION > CST > C3-A4RRegister the paper width basic value for cassette 3.9-1) Place STMTR paper in the cassette 3, and move the side guide plateto suit the STMTR width.9-2) Select C3-STMTR in service mode to highlight, and press the OKkey so that adjustment will be executed and the value will be registeredautomatically.9-3) Likewise, repeat steps 9.1) and 9.2) for A4R.Cassette 4COPIER > FUNCTION > CST > C4-STMTRCOPIER > FUNCTION > CST > C4-A4RPerform the work you performed for cassette 3.10) Exit the service mode.1) Press the release button of the front deck (left/right), and slide out thedeck.2) Loosen the 4 screws [1].Wl02468100246810[1][2][1][1][2][2]imageL1[1][1][2]
