Chapter 99-142) Make the following selections in service mode to generate output:COPIER > FUNCTION > FIXING > NIP-CHK.The A3 paper will be picked up, and a copy like the one shown in figure willbe delivered.9.5.4 External Delivery Roller9.5.4.1 Removing the External Delivery Roller 0010-9397iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Remove the 3 screws [1]; then, while opening the upper delivery as-sembly [2], remove the delivery roller guide [3].F-9-313) Remove the E-ring [1] at the front, slide the bearing [2] in the direction ofthe gear.F-9-324) Remove the E-ring [1], and slide the bearing [2] toward the rear; then, de-tach the external delivery roller assembly [3].F-9-335) Remove the E-ring [1], one-way gear [2], and bearing [3] at the rear of theexternal roller shaft; then, remove the 2 Erings [4] and the 2 rollers [5] ofeach roller.F-9-34Take care not to lose the parallel pin used in each roller.9.5.5 Internal Delivery Roller9.5.5.1 Removing the Internal Delivery Roller 0010-9398iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Remove the internal delivery roller [1], bearing [2], 3 E-rings [3], andbushing holder [4]; then, detach the drive gear [5].F-9-353) Remove the E-ring [1] and the bushing [2] at the rear of the shaft; then,detach the internal delivery roller [3].F-9-369.5.6 Main Thermistor9.5.6.1 Removing the Main Thermistor 0010-9399iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Remove the fixing web and the oil pan.3) Remove the fixing harness cover.4) Disconnect the connector [1] of the thermistor. Remove the screw [2],and shift the thermistor assembly [3] to the rear to detach.[3] [2][1][2] [1][2][1][3][5][5][4][4][3][2] [1][1] [4] [2] [3][3][5][1][2][3]
