Chapter 88-51F-8-1539) Remove the bushing [1] in the direction of the arrow, and remove the reg-istration transfer unit [2].- E-ring [3]- bushing [4]F-8-1548.11.24.2 Removing the Double-Feed Sensor(transmitting) 0011-8283iR7105 / iR7095 / iR70861) Turn over the registration transfer unit, and detach the harness protectivesheet [1].F-8-1552) Disconnect the cable [1].- 1 edge saddle [2]- 1 clamp [3]- 1 connector [4]F-8-1563) Remove the double-feed sensor assembly [1].- 1 screws [2]F-8-1574) Remove the double-feed sensor (transmitting) [1].- 1 screw [2]- 1 sensor holder [3]F-8-1588.11.25 Double Feeding Detection Sensor ( Reception )8.11.25.1 Before Starting the Work 0011-8282iR7105 / iR7095 / iR70861) Remove the developing assembly.2) Remove the primary charging assembly.3) Remove the pre-transfer charging assembly.4) Remove the process unit.8.11.25.2 Removing the Double-Feed Sensor (receiving)0011-8284iR7105 / iR7095 / iR70861) Remove the pre-transfer charging assembly fan duct assembly [1].- 4 screws [2][1][1][1][1][2][3][4][1][1] [2][3][4][1][2][1][3][2]
