Chapter 77-36F-7-697.10.7 Photosensitive Drum Heater7.10.7.1 Replacing the Photosensitive Drum Heater 0010-8835iR7105 / iR7095 / iR70861) Remove the photosensitive drum from the main body.2) Remove the two mounting screws [1], and detach the flange [2] at thefront; then, disconnect the connector [3].F-7-703) Pull out the flange at the rear [1], and detach the power supply unit [2]from the photosensitive drum.F-7-714) Pull out the flat heater (drum heater) [1] from inside the drum cylinder.F-7-72Points to Note When Mounting the FlangeThere is hardly a gap between the flange and the inner side of the drum, caus-ing the flange to get stuck if pushed at an angle.When mounting the flange, push it in a parallel direction to the drum withoutapplying excessive force.7.10.8 Sub Hopper7.10.8.1 Before Starting the Work 0011-7452iR7105 / iR7095 / iR70861) Open the manual feeder cover.2) Remove the developing assembly locking plate.3) Remove the original delivery tray [1]. (DADF-Q1 model only)- 2 screws [2]F-7-734) Remove the toner bottle.7.10.8.2 Removing the Sub Hopper Unit 0011-7550iR7105 / iR7095 / iR70861) Remove the upper rear right cover [1].- 3 screws [2][1][2][3]([3])[1][2][3][1][2][1][1][2]
