Chapter 99-18F-9-55Check the fixing cleaning belt for skew, wrapping, and wrinkling. Further,be sure that the winding direction and the mounting orientation are as indi-cated.F-9-562) After mounting the fixing cleaning belt, move the plunger [4] of the clean-ing belt feeding solenoid into the direction of the arrow.F-9-57If you have replaced the cleaning belt, be sure to return the setting underCOPIER > COUNTER > MISC > FIX-WEB to '0' in service mode.9.5.11 Claw Jam Sensor9.5.11.1 Removing the Claw Jam Sensor 0010-9540iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Remove the 2 screws, and detach the lower separation claw assembly.3) Detach the claw jam sensor [1] from the right side of the lower deliveryassembly.F-9-589.5.12 External Delivery Sensor9.5.12.1 Remove the External Delivery Sensor 0010-9543iR7105 / iR7095 / iR70861) Remove the external delivery roller.2) Remove the 2 screws [1], and disconnect the connector [2]; then, de-tach the external sensor assembly [3].F-9-593) Disconnect the connector [1], and detach the external delivery sensor [2].F-9-609.5.13 Internal Delivery Sensor9.5.13.1 Removing the Internal Delivery Sensor 0010-9545iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Open the upper delivery assembly, and remove the 2 screws [1]; then,detach the internal delivery sensor assembly [2].F-9-613) Disconnect the connector [1], and detach the internal delivery senor [2].[3] [1][2]Take up rollerCleaning beltfeeding roller[4][1][1][1][3][2][1][2][2][1][1]
