Chapter 22-84F-2-2742.10.2 Turning Off the Host Machine 0011-8636iR7105 / iR7095 / iR70862.10.3 Installation Procedure 0011-2711iR7105 / iR7095 / iR70861. Installation Procedure2. Installation1) Remove the main controller box cover [1].- 10 screws [2][1] Speaker unit (upper) 1 pc. [2] Speaker unit (lower) 1 pc.[3]* Cable (1300mm) 1 pc. [4] Cable (1850mm) 1 pc.[5] Cord guide(4 cord guide to be used)7 pc. [6] Voice Guidance Board 1 pc.[7] Voice Guidance Board Face Plate 1 pc. [8]* Voice Guidance Board Face Plate 1 pc.[9] Binding screw (M3X6) 2 pc. [10] Binding screw (M4X6) 1 pc.[11] Binding screw (M4X40) 2 pc. [12]* Binding screw (M3X16) 1 pc.[13]* Binding screw (M4X16) 1 pc. [14] Ferrite core 1 pc.[15]* Clamp 1 pc. [16] Users Guide 1 pc.[17] User Manual CD-ROM 1 pc.*Not to be used for this machineTurning Off the Main PowerWhen turning off the main power, be sure to go through the following instrict sequence to protect the machine's hard disk:1) Hold down on the power switch on the control panel for 3 sec or more.2) Operate on the touch panel according to the shut-down sequenceindicated so that the main power switch may be turned off.3) Turn off the main power switch.4) Disconnect the power cable (for the power outlet).Before starting to install the Voice Guidance Kit, check to be sure that theExpansion Bus-D1 has properly been installed.[1] [2] [3] [4] [5] [6][8] [9] [10] [14] [15][11] [12] [13][7][16] [17]
