Chapter 22-34F-2-1398) Put cassette 3/4 back inside the machine.9) When done, execute the following service mode items:10) Exit the service mode.Cassette 3COPIER > FUNCTION > CST > C3-STMTRCOPIER > FUNCTION > CST > C3-A4RRegister the paper width basic value for cassette 3.9-1) Place STMTR paper in the cassette 3, and move the side guide plateto suit the STMTR width.9-2) Select C3-STMTR in service mode to highlight, and press the OKkey so that adjustment will be executed and the value will be registeredautomatically.9-3) Likewise, repeat steps 9.1) and 9.2) for A4R.Cassette 4COPIER > FUNCTION > CST > C4-STMTRCOPIER > FUNCTION > CST > C4-A4RPerform the work you performed for cassette 3.1) Press the release button of the front deck (left/right), and slide out thedeck.2) Loosen the 4 screws [1].F-2-1403) Move the cassette guide assembly (front) [1] to the front or the rear tomake adjustments.- move the guide plate to the rear to decrease the horizontal registration(left margin).- move the guide plate to the front to increase the horizontal registration(left margin).F-2-1414) Check to see that the horizontal registration (L; left/right margin) of theimages made on paper from the front deck (left/right) is 2.5 +/-1.5 mm.F-2-142[1] Paper movement5) Tighten the 4 screws you loosened in step 2).6) Put the front deck (left/right) back in place.1) Move the side guide plate [1] to the center, and loosen the 2 manual feedertray mounting screws [2]; then, adjust the position of the manual feedertray.F-2-1431) Make the following selections in service mode: COPIER > ADJUST >FEED-ADJ > ADJ-REFER so that the image margin on the 2nd side willbe as indicated.2) Exit the service mode.- if the margin is too large, decrease the setting of ADJ-REFER (a changeof 10 will decrease the margin by 1 mm).- if the margin is too small, increase the setting of DJ-REFER (a changeof 10 will increase the margin by 1 mm).W1=2.5 +/-2.0 mm[1][2][1][1][1]imageL1[1][2][1]
