Chapter 77-381) Open the manual feeder tray cover.2) Remove the pull-off roller unit.3) Removing the developing assembly stay.7.10.9.2 Removing the Developing Assembly 0010-8836iR7105 / iR7095 / iR70861) Disconnect the two connectors [1], and slide out the developing assembly[2] to the front.F-7-827.10.9.3 Points to Note When the Developing Assembly0011-8148iR7105 / iR7095 / iR7086When mounting the developing assembly, take care not to hit against the de-veloping cylinder [1].F-7-83Check to be sure that the connector [1] will not become disconnected. Poorcontact will lead to blank prints.F-7-84Check to be sure that the developing assembly locking plate is free of a gapand displacement, which are likely to cause image faults. (Especially, it mustnot be riding over the bosses found below.)When mounting the developing assembly locking plate, take care not to trapthe cable [1].F-7-85ÉRÉlÉNÉ^ÉJÉoÅ[ÇšéÊïtÇØÇÈç¤ÅAñ‘ä|ÇØïî[1]ÇšÉJÉoÅ[ÇÃäOë§Ç…èoDzDZÇýÅB(ë©ê¸ÉoÉìÉh[2]ÇÕïKdzÉJÉoÅ[ÇÃì‡ë§Ç…DzÇÈDZÇýÅB)F-7-867.10.9.4 Removing the Hopper 0010-8842iR7105 / iR7095 / iR70861) Remove the developing assembly.2) Remove the four mounting screws [1], and disconnect the connector [2];then, detach the hopper [3].F-7-87[1] [1][2][1][1][1][1][1][2][3][1][2]
