Chapter 88-368.11 Parts Replacement Procedure8.11.1 Cassette Pickup Assembly8.11.1.1 Removing the Right Deck / Cassette PickupAssembly 0011-0030iR7105 / iR7095 / iR7086The removal procedure of a right door and a left door is the same. An illus-tration makes a right door an example and explains it.1) Slide out the right deck / cassette 3 / cassette 4.2) Open the right upper cover and the right lower cover.An attempt to remove the pickup assembly without removing the deck willcause the lifter to get trapped, not holding the pickup assembly from slidingout.3) Remove the mounting screw [1], and detach the connector cover [2]; then,disconnect the connector [3].4) Remove the three mounting screws [4], and detach the pickup assembly[5].F-8-568.11.1.2 Removing the Vertical Path 3/4 Sensor and theCassette 3/4 Pickup Sensor 0011-0032iR7105 / iR7095 / iR70861) Remove the cassette 3/4 pickup assembly.2) Remove the screw, and detach the static eliminator [2].3) Remove the screw [3], and detach the pickup assembly sensor base.F-8-574) Disconnect the connector [1] (1 pc. each), and free the claw; then, detachthe vertical path 3/4 sensor [2] and the cassette 3/4 pickup sensor [3].F-8-588.11.2 Cassette Lifter Motor8.11.2.1 Removing the Lifter Motor (M16/M17) of theCassette (3/4) 0010-8958iR7105 / iR7095 / iR70861) Slide out the front deck (right); then, slide out the cassette 3/4.2) Remove the front lower right cover of the cassette assembly as instructedunder "Removing the Vertical Path Roller 2."3) Remove the two fixing screws [1] of the lifter motor (M16/M17), and dis-connect the connector [2]; then, detach the lifter motor [3].F-8-598.11.3 Right Deck Pickup Assembly8.11.3.1 Removing the Right Deck / Cassette PickupAssembly 0011-8492iR7105 / iR7095 / iR7086The removal procedure of a right door and a left door is the same. An illus-tration makes a right door an example and explains it.1) Slide out the right deck / cassette 3 / cassette 4.2) Open the right upper cover and the right lower cover.An attempt to remove the pickup assembly without removing the deck willcause the lifter to get trapped, not holding the pickup assembly from slidingout.3) Remove the mounting screw [1], and detach the connector cover [2]; then,disconnect the connector [3].4) Remove the three mounting screws [4], and detach the pickup assembly[5].[3][4][4][5][1][2][2][3][4][1][1][1][3][2][1][2][2][3][3]
