Chapter 1717-9117.6.3 SORTER17.6.3.1 SORTER Items 0018-2759iR7105 / iR7095 / iR7086T-17-65SORTER > OPTIONSub item Description LevelBLNK-SW Use it to set the margin width for the left and right sides of the crease when the saddle stitcher is used.1settings0: normal width (5 mm); 1: large width (10 mm); 2: no margin (default)MD-SPRTN Use it to enable/disable bare-minimum (regression) mode.1settings0: normal operation (default); 1: enable bare-minimum operation (no stapling, alignment)SDL-PRS Use it to specify saddle stitcher press operation.1settings0: enable pressing (one-way; default); 1: disable pressing; 2: enable pressing (both ways)BUFF-SW Use it to enable/disable buffer operation of the finisher.1settings0: enable buffer operation (fault); 1: disable buffer operationThe use of paper with a low friction coefficient (e.g., coated paper) tends to cause displacement in the buffer assembly. If such is thecase, set it to '1' (a drop in productivity, however, will be a trade-off).TRY-EJCT Use it to switch over delivery operation for the stack tray of the finisher.1settings0: normal operation (default); 1: delivery for thin paperThe use of thin paper (i.e., paper with little body) can cause poor stacking. If such is the case, set it to '1'.PN-SKEW Use it to increase the accuracy of punch hole positioning (in the direction of horizontal registration).1settings0: normal mode (default); 1: hole position enhancement modeIf an increase in the accuracy of punch hole positioning is desired when the puncher unit is in use, set it to '1'.standard: +/-1.0 mm -> +/-0.5 mmA trade-off will be a drop in productivity (100 -> about 80 ppm).CNTR-OUT Use it to set the delivery center position for the stacker.2settings0: disable center position delivery (default); 1: enable center position deliveryThis mode item is valid when a stacker is connected.
