Chapter 1818-87) When a message has appeared to indicate that the system software has been installed, click [OK].F-18-718.2.2 Copying the System Software (SST -> USB) 0011-6752iR7105 / iR7095 / iR7086Here, you will be copying the system software from the SST to a USB device.[Preparatory Work]Requirements- PC to which the SST (version 3.21 or later) has been installed- USB device *You will not be able to use a security-protected USB device. Be sure to remove the protection before use.[Copying the System Software]1) Start up the PC.2) Connect the USB device to the USB port of the PC.3) Start up the SST.*: USB RequirementsInterface USB 1.1 or higher (USB 2.0 recommended)Capacity 1 GB or more recommended (A set of system software is in excess of 512 MB.)Format FAT (FAT16), FAT32 (It must not be NTFS or HFS.)single partition (There must not be multiple partitions.)CONTROLRegisterd Firms Found FirmiR7105iRYYYYHDFormatXXxxv0002 >>> RegistBOOTXXxxv0103 >>> RegistUSenv0112 >>> With noSYSTEMXXxxv0111 >>> RegistTTSXXenv0111 OK!KEYXXenv0107 >>> RegistRUIXXenv0112 >>> RegistLANGUAGEXXxxv0100 >>> RegistBROWSERXXxxv0102 >>> RegistDCONXXxxv0105 >>> RegistMEAPCONTXXxxv6102 >>> RegistG3FAXTTSXXenv0111iRCXXXXHDFormatXXxxv0002KEYXXxcv0101XXxpv0101SDICTRegistered fir mware Fir mware registration completed.>>> Batch Registration ResultsC l i ck a bu t t o n t o exe c u t e .CONNECTCANCELEXITO KRegister Fir mwareDelete Fir mwareDelete Backup DataSystem ManagementService Support Tool DLM0 (Ver.3.21E)
