Chapter 22-2F-2-1[A]: zone A; a site that satisfies all requirements imposed by quality standards.[B]: zone B; a site that may fail to satisfy some of the requirements imposed by quality standards as fully as a site in zone A. Some of the items may not beapplicable to the site.[C]: zone C: a site free from concerns, malfunctions, and wrong indications that can affect safety, permitting normal machine operation.3) The machine must not be installed near a source of fire or in an area subject to dust or ammonium gas. If the area is subject to direct rays of the sun, there mustbe shades or curtains to block the rays.4) The level of ozone generated by the machine is not likely to affect the health of the individuals around it. Some, nevertheless, may find the odor rather unpleasant,and it is important that the room be well ventilated.5) The machine's feet must be in contact with the floor, and the machine must remain level.6) There must be enough space around the machine for printing work. (See the installation space.)7) Be sure the area is well ventilated.If multiple machines exist, it is important to make sure that the exhaust from another machine will not be drawn into the machine. Also, the machine must notbe installed near the air vent of the room.F-2-22.1.4 Installation Space 0011-6508iR7105 / iR7095 / iR7086Diagram of the Work SpaceThere must be enough space around the machine. The following diagram shows the minimum dimensions; whenever possible, be sure there will be more space thanMEMO:In general, the silicon gas (vapor of silicone oil from the fixing assembly)tends to soil the corona charging wire, reducing its life. This is particularlytrue of a low humidity environment.)100(%RH)(degC)90857570502025151050 107.5 23 27.5 32.515 20 25 30 35 40[A][B][C]
