Chapter 22-301) Slide out the duplexing unit, and check to make sure there is no foreignmatter and damage.2) Check to make sure that the main power switch is at OFF; then, connectthe machine's power plug to the power outlet.3) Turn on the main power switch by shifting it to ON.- A screen appears indicating that programs are being loaded.- A message appears indicating that the machine is starting up.2.2.14 Stirring the Toner 0011-1246iR7105 / iR7095 / iR7086When the wait period is over, start service mode to supply toner to the devel-oping unit.1) Start service mode. ( > '2' and '8' at the same time > )2) Make the following selections: COPIER > FUNCTION > INSTALL >TONER-S.3) See that the following message has appeared: "Check the Developer."4) Check to see that the developing assembly is mounted properly; then,press the OK key.- The supply operation lasts about 8 to 10 min, and stops automatically.(At the end of the operation, the message "STOP!" appears.)5) End service mode.2.2.15 Stirring the Toner 0012-2467iR7095PWhen the wait period is over, start service mode to supply toner to the devel-oping unit.1) Start service mode. ( > '2' and '8' at the same time > )2) Make the following selections: COPIER > FUNCTION > INSTALL >TONER-S.3) See that the following message has appeared: "Check the Developer."4) Check to see that the developing assembly is mounted properly; then,press the OK key.- The supply operation lasts about 8 to 10 min, and stops automatically.(At the end of the operation, the message "STOP!" appears.)5) End service mode.2.2.16 Index Sheet Attachment 0010-8965iR7105 / iR7095 / iR7086 / iR7095P1) Choose cassette 1 or 2 for use with index sheets.Press the release button of the cassette you have chosen, and slide out thecassette.Match the 2 one-touch supports [1] against the holes [2] of the cassette,and fit in the pins to attach.2) Holding it so that the protrusion is at the top, match the hole in the indexsheet attachment [3] against the one-touch support [1].3) Place the base sheet [4] into the cassette, and put the cassette back into themachine.F-2-1202.2.17 Others 0011-9786iR7105 / iR7095 / iR70861) Affix the shut down instruction label [1] in the appropriate language onthe indicated position.F-2-121iR7086 Only1) Fit the Cleaning Position label [1] as indicated on the front cover, and at-tach it in place.F-2-1221) Fit the Original Size label [1] as indicated on the ADF open/close cover,and attach it in place.Be sure to remove all packing material from inside the cassette beforeturning on the main power.Do not perform the following while the machine is in operation:- turning off the power- opening/closing the ADF- opening/closing any of the various covers- opening/closing the cassettes- opening/closing the deckDo not perform the following while the machine is in operation:- turning off the power- opening/closing any of the various covers- opening/closing the cassettes- opening/closing the deck[2][3][4][1][1]ON[1][1]
