Chapter 1717-117.1 Outline17.1.1 Service mode screen configuration 0011-5845iR7105 / iR7095 / iR7086As shown below, the service modes use three screen levels: initial screen -> main/intermediate item screen -> sub-item screen.One set of modes are used for normal maintenance (Level 1 modes), and another set are used for troubleshooting (Level 2 modes).F-17-1The copier has the 7 service modes listed below.F-17-217.1.2 Entering or selecting service modes 0011-5846iR7105 / iR7095 / iR7086To execute a copier operation using a service mode, remove the cable from the external controller or the cable from the network before entering the desired mode.Take care when using the FUNCTION (operation/inspection mode) mode, as the copier may malfunction and be damaged if a print job is received from outsidewhile an operation is executing with this mode in effect.1) Press the asterisk key ( ) on the operation panel.Initial screen(Level 1)Main/intermediateitem screen(Level 1)Sub-item screen(Level 1)Sub-item screen(Level 1)User screenInitial screen(Level 2)Reset keyPrevious/next page( )(2,8)( )(Select a main item from the top of screen.)(The corresponding intermediate items arethen displayed and can be selected.)(Select an item.)Main/intermediateitem screen(Level 2)Sub-item screen(Level 2)Sub-item screen(Level 2)Previous/next page(Select a main item from the top of screen.)(The corresponding intermediate items arethen displayed and can be selected.)(Select an item.)( )(2)COPIERFEEDERSORTERBOARDDISPLAYI/OADJUSTFUNCTIONOPTIONTESTCOUNTERStatus display modeI/O display modeAdjustment modeOperation/inspection modeSpecifications setting modeTest print modeCounter mode