Chapter 22-112.2 Unpacking and Installation2.2.1 Points to Note When Turning On/Off the Main Power0011-4949iR7105 / iR7095 / iR7086 / iR7095P2.2.2 Unpacking 0010-8941iR7105 / iR7095 / iR70861) Unpack the machine.Open the plastic bag.2) Remove the grip cover (rear) [1] found on the right side of the machineusing a flat-blade screwdriver, and shift up the grip [2] found at the rear.F-2-113) Take out the grip [1] from the contents box.F-2-124) Open the upper right cover and slide the face cover (small) [1] in the di-rection of A arrow. Then, detach the face cover (large) [2] in the directionof B arrow.F-2-135) Insert the grip [1] taken out in step 3) into the machine at an angle whileholding down the spring [2]; then, keep the grip in horizontal orientationso that the claw [3] is hooked on the plate at the rear.F-2-146) Close the upper right cover.7) Shift up the grip (front, rear) [1] found on the left side of the machine.F-2-158) Holding the grips (front, rear) on the delivery side of the machine, lift themachine slightly to remove the pad.At this time, put away the plastic bag toward the pad.Turning Off the Main Power (host machine)Be sure to go through the following when turning off the main power toprotect the hard disk:1. Hold down the control panel power switch for 3 sec or more.2. Go through the instructions on the shut-down sequence screen so that themain switch may be turned off.3. Turn off the main power switch.4. Disconnect the power cable (for the power outlet).Order of Turning On the Machines (host machine + accessories)When mounting delivery options, such as finisher, be sure to turn on thepower of main body and option.If you do not turn on the power in the correct order, the main body cannotdetect the option.1. high-capacity stacker, perfect Binder, finisher (either)2. professional puncher3. host machine[1][2][1]Be sure to go through steps 8) and 9) in correct sequence; otherwise, themachine can become displaced.[1][2][B][A][1][2][3][1][1]
