Chapter 22-13F-2-2217) Open the upper right cover, and mount the face cover (small, large).18) Close the upper right cover.2.2.3 Unpacking 0012-2132iR7095P1) Unpack the machine.2) Remove the grip cover (rear) [1] found on the right side of the machineusing a flat-blade screwdriver, and shift up the grip [2] found at the rear.F-2-233) Take out the grip [1] from the contents box.F-2-244) Open the upper right cover and slide the face cover (small) [1] in the di-rection of A arrow. Then, detach the face cover (large) [2] in the directionof B arrow.F-2-255) Insert the grip [1] taken out in step 3) into the machine at an angle whileholding down the spring [2]; then, keep the grip in horizontal orientationso that the claw [3] is hooked on the plate at the rear.F-2-266) Close the upper right cover.7) Shift up the grip (front, rear) [1] found on the left side of the machine.F-2-278) Holding the grips (front, rear) on the delivery side of the machine, lift themachine slightly to remove the pad.At this time, put away the plastic bag toward the pad.If condensation is found on the outside or inside of the machine at this point,stop the work and wait unit the machine becomes fully used to the roomtemperature. Resume the work after making sure that the machine is free ofcondensation.[2][1][1][2][1]Be sure to go through steps 8) and 9) in correct sequence; otherwise, themachine can become displaced.[1][2][B][A][1][2][3][1][1]