Chapter 77-39F-7-887.10.10 Developing Cylinder7.10.10.1 Removing the Developing Cylinder 0010-8847iR7105 / iR7095 / iR70861) Remove the developing assembly.2) Remove the hopper assembly.3) Remove the blade unit.4) Remove the three mounting screws [1] from the rear, and detach the de-celeration gear retainer [2].F-7-895) Remove the three gears [1].F-7-906) Remove the E-ring [1], and detach the pressure arm [2].F-7-917) Remove the E-ring [1], gear [2], pressure roll [3], washer [4], grip ring [5],seal [6], butting roll [7], washer [4], and bearing [8] in the order indicated.F-7-928) Remove the E-ring [1] and the pressure arm [2] at the front.F-7-939) Remove the C-ring [1], washer [2], pressure roll [3], seal [4], washer [2],butting roll [5], C-ring [1], and bearing [6]; the, remove the two screws[7], and detach the bushing [8] and then the developing sleeve [9].F-7-94Do not leave fingerprints or oil on the surface of the developing cylinder.Wipe off any with lint-free paper. (Do not use solvent.)[1][1][1][1] [2][1][1][2][1][2][3][4][4][5][6][7][8][1] [2][1][1][2][2][3][4][5][6][7][8][9]
