Chapter 77-42F-7-1064) Remove the screw [1], and detach the fixing plate [2]; then, disconnect theconnector [3], and detach the transfer/separation charging assembly [4].F-7-107Points to Note When Mounting- The transfer/separation charging assembly is equipped with a positioningboss on its front and rear.When mounting the assembly, be sure to hook the bosses on the cut-offsin the stay.- If the charging assembly cleaner is on the front side, the home position de-tecting microswitch can become damaged; be sure to set the chargingcleaner at the center.F-7-108F-7-1097.10.15 Pre-Transfer Exposure LED7.10.15.1 Removing the Pre-Transfer Exposure LED 0010-8878iR7105 / iR7095 / iR70861) Slide out the pre-transfer charging assembly.When placing the removed pretransfer charging assembly, be sure to takecare not to subject the LED to impact.2) Turn over the pre-transfer charging assembly, and remove the 3 screws [1]found on the bottom; then, detach the LED cover [2].F-7-1103) Disconnect the connector [1], and remove the pre-transfer exposure LED[2].F-7-1117.10.16 Separation Claw/Separation Claw Drive Assembly7.10.16.1 Separation Claw/Separation Claw DriveAssembly 0010-8880iR7105 / iR7095 / iR70861) Open the front cover.2) Take out the process unit.3) Remove the E-ring [1], and slide out the separation claw holder shaft [2]to the front to detach the separation holder [3].F-7-1124) Remove the spring [1], and detach the separation claw [2].[1][2][1][2][3][4]BossBossBoss Boss[1][2][1][2][2][3][1]
