Chapter 99-19F-9-629.5.14 Reversal Sensor9.5.14.1 Removing the Reversal Sensor 0010-9548iR7105 / iR7095 / iR70861) Remove the fixing assembly from the machine.2) Open the upper delivery assembly; then, remove the screw [1], and de-tach the reversal sensor [2].F-9-639.5.15 Fixing Inlet Sensor9.5.15.1 Before Starting the Work 0011-7951iR7105 / iR7095 / iR70861) Remove the fixing assembly.2) Remove the fixing web, and clean the oil pan.3) Remove the 2 fixing heaters.4) Remove the screw [1], and detach the locking support plate [2] found atthe front.F-9-645) Remove the screw [1], and detach the locking support plate [2] found atthe rear.F-9-656) Open the fixing upper unit [1].F-9-66When opened, the fixing upper unit is in an unstable state. Use the shift ofthe screwdriver as a support as shown.7) Remove the 2 screws [1], and detach the lower separation claw supportplate [2].F-9-678) Remove the fixing lower roller.9) Remove the fixing inlet guide [1].- 2 screws [2]10) Remove the 2 screws [3].F-9-689.5.15.2 Removing the Fixing Inlet Sensor/Fixing Inlet HPSensor 0011-7953iR7105 / iR7095 / iR7086[1][2][1][2][2] [1][1] [2][1][1][1][2][1] [2][2] [3]
