Chapter 22-46F-2-17719) Mount the card reader base to the upper front cover unit.20) Mount the upper front cover unit lower cover to the upper front cover unit.21) Lead the cable [1] of the card reader to the front of the upper front cover unit [2], and mount the upper front cover unit [2] to the machine.- 3 screws [3]F-2-17822) Connect the connector [1] of the machine and the relay connector [2] of the card reader.F-2-17923) Mount the covers by going through the steps used to remove them but only in reverse:- mount the upper inside cover.- connect the connector.- mount the process unit cover.- mount the primary charging assembly front cover.- push in the fixing transport unit.- close the front cover and the hopper cover.24) Connect the machine's power plug, and turn on the main power switch.2.5.4 Installing the Card Reader-D1 0012-2059iR7095P1) Start service mode, and make the following selections:COPIER > FUNCTION > INSTALL > CARD; then, type in the lowest of the card numbers to be used (1 through 2001). As many as 1000 cards starting withthe number you have entered may be used.2) Go through the shut-down sequence to turn off the main power.3) Open the hopper cover [1].Take care not to trap the cable by the upper front cover unit and the upperfront cover unit lower cover.[2][1][1][3] [2][1][1] [2]
