Chapter 88-49F-8-1392) Disconnect the connector [3]; then, remove the screw [4], and detach thepostconfluence sensor [5].F-8-1408.11.22.13 Removing the Front Deck (lifter) Draw-OutSensor 0010-9376iR7105 / iR7095 / iR70861) Disconnect the connector [1] from the bottom of the duplexing unit; then,remove the screw [2], and detach the front deck (left) feed sensor [3].F-8-1418.11.22.14 Removing the Horizontal Registration Sensor0010-9377iR7105 / iR7095 / iR70861) Remove the duplexing unit from the main body.2) Remove the front cover.3) Disconnect the connector [1], and remove the three screws [2].F-8-1424) Remove the screw [3], and detach the duplexing unit right fixing assembly[4]; then, remove the two screws [5] at the rear, and detach the right gripplate [6].F-8-143When mounting the right grip plate, be sure that the boss on the grip plate isin the hole of the side plate.5) Remove the screw [7], and detach the horizontal registration sensor [8].F-8-1448.11.23 Separation Roller8.11.23.1 Removing the Separation Roller 0010-9378iR7105 / iR7095 / iR70861) Remove the two mounting screws [1], and remove the feeding guide plate[2]; then, detach the open/close guide [3]. (Skip this step for the pickupassembly of the front deck left.)F-8-1452) Remove the two mounting screws [4], and remove the separation roller as-sembly [5] from the joint. (If for the pickup assembly of the front deckleft, remove one screw.)[1][1][2][3][5][4][1][3][2][2][2][1][6][4][3][5][8] [7][1] [1][2] [3]
