Chapter 22-21- screw (RS tightening; M4X10) [2]F-2-682.2.9 Mounting the Pickup Assembly 0010-8957iR7105 / iR7095 / iR7086 / iR7095P1) Shift the lever [1] in the direction of the arrow, and remove the pickup roll-er release spacer [2].F-2-692) Open the manual feed cover.3) Push the release button of the front deck (right) and the cassette 3/4, andslide them out halfway.4) Slide out the cassette 3/4, and remove the packing tape from where thehost machine and the cassette come into contact (left side of the host ma-chine and right side of cassette 4).5) Open the upper right cover [1] and the lower right cover [2], and removethe 3 pickup roller release spacers [3].F-2-706) Close the upper right cover and the lower right cover.7) Close the front deck (right) and the cassette 3/4.8) Press the release button of the front deck (left), and slide out the deck.9) Mount the included deck locking plate [1] to the front deck (left).- screw (RS tightening; M4X10; white) [2]F-2-7110) Close the front deck (left).2.2.10 Mounting the Control Panel 0011-4903iR7105 / iR7095 / iR70861) Remove the upper rear right cover [1].- 3 screws [2]F-2-722) Match the 2 bosses [3] of the arm cover 3 [2] with the Control panel armunit [1], and fix it in place with a screw (binding; M4X10) [4].MEMO:If the deck/cassette is inside the machine, the spacer is locked in place andcannot be removed; be sure to slide the unit out halfway to unlock it.[1][2][1] [2][1][2][3][1][2][2][2][1]
