Chapter 1010-13F-10-1910.5.1.10 Reader Controller Cover10.5.1.10.1 Removing the Reader Controller Cover0017-9845iR7105 / iR7095 / iR7086 / iR7095P1) Remove the original size sensor unit (rear).2) Remove the 2 screws [1], and detach the flexible cable [2] togetherwith the cover sheet [3].3) Disconnect the flexible cable [2] from the connector [4].F-10-204) Remove the 6 screws [1], and detach the reader controller cover [2].F-10-2110.5.2 Left Pickup Drive Assembly10.5.2.1 Removing the Left Pickup Drive Assembly 0010-9572iR7105 / iR7095 / iR7086ConstructionF-10-221) Remove the rear cover.2) Open the main controller box assembly.3) Remove the high-voltage PCB unit.4) While detaching the belt [1], remove the three screws [2], and detachthe left pickup drive assembly [3].F-10-2310.5.3 Pickup Drive Assembly10.5.3.1 Removing the Pickup Drive Assembly 0010-9576iR7105 / iR7095 / iR7086ConstructionF-10-241) Remove the rear cover.2) Remove the high-voltage PCB unit.3) Remove the flywheel.4) Remove the drum gear.5) Remove the waste toner pipe.6) Remove the two screws [1], and loosen the harness guide [2]; discon-nect the two connectors [3], and remove the six screws [4]; then, detachthe pickup drive assembly [5].[1] [2][2] [3] [1][4][1][1] [1] [1][2] [1][1] [3] [2][2][2]
