Chapter 22-15F-2-3417) Open the upper right cover, and mount the face cover (small, large).18) Close the upper right cover.2.2.4 Mounting the Scanner System 0010-8943iR7105 / iR7095 / iR70861) Open the ADF.Remove the copyboard glass protective pad and tape.2) Remove the scanner system fixing screw [1].(Store the screw away for possible relocation of the machine in thefuture.)F-2-352.2.5 Mounting the Fixing Assembly 0010-8944iR7105 / iR7095 / iR7086 / iR7095P1) Open the front cover.2) Shift the fixing transport assembly release lever [1] in the direction of thearrow to unlock the transfer/separation charging assembly.F-2-363) Slide out the fixing transport unit [1] to the front.F-2-374) Remove the tape [1]; then, remove the tag [2] of the fixing transport as-sembly and the separation release member [3].F-2-385) Remove the tape used to keep the tag in place, and open the delivery as-sembly [1]; then, remove the 2 fixing nip release screws [2] from the frontand the rear.F-2-396) Close the delivery assembly.2.2.6 Mounting the Charging Assembly 0010-8947iR7105 / iR7095 / iR70861) Remove the transfer separation charging assembly front cover [1].- screw [2]If condensation is found on the outside or inside of the machine at this point,stop the work and wait unit the machine becomes fully used to the roomtemperature. Resume the work after making sure that the machine is free ofcondensation.[2][1][1][1]Remove all foreign matter (e.g., glue from tape) from the transport belt.[1][1] [3][2][1][2]
