Chapter 77-33F-7-51Waste toner can drop on the duplex unit when the process unit is removed.After mounting the process unit. be sure to slide out the duplex unit and re-move the waste toner.7.10.2 Pre-Exposure Lamp7.10.2.1 Removing the Pre-Exposure Lamp Unit 0010-8819iR7105 / iR7095 / iR70861) Open the front cover.2) Slide out the process unit.Cover the drum with A3 paper or the like when you have slid out the processunit.3) Disconnect the connector [1], and remove the two screws [2]; then, detachthe preexposure unit [3].F-7-524) Remove the three screws [1], and detach the pre-exposure holder [2]; then,detach the pre-exposure lamp [3].F-7-53F-7-547.10.3 Primary Charging Assembly7.10.3.1 Removing the Primary Charging Assembly 0010-8821iR7105 / iR7095 / iR70861) Open the front cover.2) Remove the primary charging assembly over [1].- 1 screw [2]F-7-553) Disconnect the connector [1]; then, while turning the stop lever [2] in thedirection of the arrow, slide out the primary charging assembly [3].F-7-567.10.4 Pre-Transfer Charging Assembly7.10.4.1 Removing the Pre-Transfer Charging Assembly0010-8823iR7105 / iR7095 / iR7086[1][2][3] [4][5][1][2][3][1][2][3][2][1][2] [3][1]
