|
Chapter 1717-9217.6.4 BOARD17.6.4.1 BOARD Items 0011-6132iR7105 / iR7095 / iR7086T-17-6617.7 TEST (Test Print Mode)17.7.1 COPIER17.7.1.1 COPIER Items 0011-6092iR7105 / iR7095 / iR7086T-17-67T-17-68BOARD > OPTIONSub item Description LevelFONTDL Use it to enable/disable display of the service setup screen for fonts listed by the PS kanji font downloader.1settings0: disable display (default); 1: enable displayMENU-1to MENU-4Use it to enable/disable display of levels 1 thorough 4 for the printer setup menu.2settings0: disable display (default); 1: enable displayCOPIER > TEST > PGSub item Description LevelTYPE Use it to select a type of test print. 11) Select the item, and type in the number of the test print you want.2) Press the Start key so that test printing starts.3) When done, put back the value to '0'.settings: 0 to 500: image from CCD (normal print); 1: grid; 2: 17-gradation (error diffusion); 3: 17-gradation (dither screen); 4: blank; 5: halftone 80H(error diffusion); 6: halftone 80 H (dither screen); 7: solid black; 8: horizontal lines (space: 27 dots; line width: 40 dots); 9: horizontallines (space: 50 dots; line width: 60 dots); 10: horizontal lines (space: 3 dots; line width: 2 dots); 11: halftone 60 H (error diffusion);12: halftone 60 H (dither screen); 13: halftone 30 H (error diffusion); 14: halftone 30 H (dither screen); 31: 1200-dpi vertical lines(space: 21 dots; line width: 8 dots); 32: 1200-dpi horizontal lines (space: 21 dots; line width: 8 dots); 33: for check on displacement ofimage in main scanning directionTXPH Use it to set the image mode for test printing. 1settings: 0 to 40: text (default); 1: photo; 2: auto; 3: text/photo/map; 4: film printPG-PICK Use it to select the source of paper for test printing. 1settings: 1 to 81: right deck (default); 2: left deck; 3: cassette 3; 4: cassette 4; 5: side paper deck; 6: manual feeder tray; 7 to 8: not used;2-SIDE Use it to set the output mode for test printing. 1settings:0: simplexing; 1: duplexingPG-QTY Use it to set a copy count for test printing. 1setting:1 to 999 (default: 1)COPIER > TEST > NETWORK***: up graded versionSub item Description LevelPING Use it to issue the PING command.1Use it to check the connection between the machine and the network (TCP/IP only).Use it to check the connection to the network at time of installation or when suspecting a fault in the connection to the network.IPV6-ADR***Destination address of PING (IPv6)1Set the destination address of PING issued in "COPIER>TEST>NETWORK>PING-IP6".IPv6 addressHexadecimal characters (0-9, a-f) and separators (:)(.), 39 characters at maximumIt should be a consistent character string as an address of IPv6.UsagePING is issued to check continuity in the network in the IPv6 environment.Set the destination address of IPv6 in this mode.
|
