Chapter 1313-313.3 Scheduled Servicing Basic Procedure13.3.1 Scheduled Servicing Basic Procedure 0010-9511iR7105 / iR7095 / iR70861. As a rule, perform schedule servicing every 500,000 prints.2. Before setting out for a visit, check the service book, and take parts for which replacement is expected.3. If cleaned with alcohol, each charging wire must be checked to make sure that it is fully dry (solvent) before putting it back in the machine.4. If left alone for a long time in an area subject to dust, humidity, or oil smoke, the power plug can collect dust, which will absorb moisture to suffer an insulationfault, turning into a possible source of fire.Be sure to disconnect it on a periodical basis, and clean it and the area around the power outlet using a dry cloth.T-13-325 Separation rolle(deck, cassette)FB5-6586-000 4 500,000 actual number of prints(1 pc. for each paper source)actual number may be checked in service mode*left deck: LD-SP-RLright deck: RD-SP-RLcassette 3: C3-SP-RLcassette 4: C4-SP-RL26 Pickup roller(manual feed tray)FF5-7829-030(front)FF5-7830-000(rear)2 120,000 actual number of printsactual number may be checked in service mode*M-PU-RL27 Feeding roller(manual feed tray)FB4-2035-000 2 120,000 actual number of printsactual number may be checked in service mode*M-FD-RL28 Separation roller(manual feed tray)FB2-7545-000 1 120,000 actual number of printsactual number may be checked in service mode*M-SP-RL29 Cleaner side scraper (font) FB5-6868-000 1 1,000,00030 Cleaner side scarper (rear) FB5-6869-000 1 1,000,00031 Developing Cylinder Clutch FH6-5015-020 1 1,000,00032 Developing Cylinder Decelerating Clutch FH6-5017-020 1 1,000,000*: Use the following service mode item: COPIER > COUNTER > DRBL-1.As of Nov 2005No. Step Work Remarks1 Report to the person in charge. Check the general condition.2 Record the counter reading. Check the faulty output.3 Make test prints. a. image densityb. soiling of white backgroundc. character clarityd. lead edge margine. fixing, registration (for displacement), back(for soiling)Standard (simplexing)lead edge: 4.0+1.5/-1.0mmleft/right: 2.5±1.5mmtrail edge: 2.5±1.5mm4 Clean the charging assemblies:- charging wire (primary, pre-transfer, transfer/separation)- grid wire (primary charging assembly)- charging assembly shielding plate- roller electrodeDry wipe with lint-free paper, and clean with alcohol.As of Nov 2005No. Parts name Parts No. Q'ty Life (pages) Remarks
