Chapter 77-46F-7-1315) From the cut-off of the shielding plate [1], free the felt holder [2].6) Pick the wire cleaner with a pair of fine-tipped pliers, and free the hookwith your finger.F-7-1327.10.19.4 Stringing the Charging Wire 0010-8939iR7105 / iR7095 / iR7086As a rule, the charging wire (except the grid wire) may be strung in the sameway for all charging assemblies. The following uses the primary charging as-sembly as an example:1) Remove the 2 screws [1], and detach the shielding plate (left, right) [2] ofthe charging assembly.To prevent deformation (slack) of the primary charging assembly, be sureto work on the left and right shielding plates separately. (Do not loosenthe screw for the left/right shielding plate.)2) Remove the wire cleaner.F-7-133For other charging assemblies, remove the lid (2 pc.)3) Free a length of about 5 cm from a charging wire reel (wire dia. of 0.06mm), and form a loop at the end about 2 mm in diameter.F-7-134MEMO:To form a loop, wind the charging wire once around a hex key, and twist thekey 3 to 4 times.4) Cut the end (excess) for the twisted charging wire.5) Hook the loop on the stud.6) Hook the charging wire on the charging wire positioner at the rear, andhook the charging wire tension spring on the charging wire, and twist it.F-7-1357) Cut the excess of the charging wire with a nipper.8) Pick the end of the charging wire tension spring with tweezers, and hookit on the charging wire terminal. In the case of the pre-transfer chargingassembly, hook the spring at the front.F-7-136Be sure of the following:- The charging wire is free of bends and twists.- The charging wire is in the bottom of the V-groove of the charging wirepositioner.F-7-1379) Fit the cushion to the front of the charging wire. (except for primary charg-ing assembly)10) Mount the shielding plate (left, right).For other charging assemblies, fit the lid (2 pc.).After stringing the charging wire of each charging assembly, check to makesure that the length of the tension spring is as follows:[1] [2][1][5]Cut offCut off[2] [1][1]StudReelCharging wireChargingterminal(front) (rear)Grid side(correct) (wrong)
