Chapter 1010-16F-10-3710.5.8.2 Removing the Lifter Drive Assembly (left deck)0010-9596iR7105 / iR7095 / iR7086ConstructionF-10-381) Remove the rear cover.2) Open the main controller box assembly.3) Remove the DC controller assembly.4) Disconnect the three connectors [1], and remove the four screws [2];then, detach the lifter drive assembly (for the left deck) [3].F-10-3910.5.9 Main Drive Assembly10.5.9.1 Removing the Main Drive Assembly 0010-9599iR7105 / iR7095 / iR7086ConstructionF-10-401) Remove the rear cover.2) Remove the high-voltage PCB unit.3) Remove the flywheel.4) Remove the drum gear.5) Remove the waste toner pipe.6) Remove the drum drive assembly.7) Remove the waste toner drive assembly.8) Disconnect the two connectors [1], and remove the nine screws [2];then, detach the main drive assembly [3].F-10-41When mounting the main drive assembly, be sure to slide out the fixing/feed-ing assembly in advance. (A coupling and a spring are mounted to the backof the main drive assembly. If the fixing/feeding assembly is inside, the ac-tion of the spring will hinder mounting work.)10.5.10 Drum Drive Assembly10.5.10.1 Removing the Drum Drive Assembly 0010-9601iR7105 / iR7095 / iR70861) Remove the HV-DC PCB.2) Remove the 2 screws [1], and detach the flywheel [2].F-10-423) Loosen the 2 screws [1] (w/ hex hole), and remove the binding screw [2](w/spring); then, detach the gear [3] of the drum shaft.[3][3] [3][2][2][1][4][1] [1][1][2] [2][2][3][2] [1] [2][2][2] [2] [3] [2][1] [2]
