|
Chapter 1717-5517.5.2 FEEDER17.5.2.1 FEEDER Items 0011-6095iR7105 / iR7095 / iR7086T-17-46FEEDER > FUNCTION*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).**: model equipped with DADF-M1 (outside Japan: iR7086).Sub item Description LevelSENS-INT Use it to adjust the sensitivity of the various sensors of the ADF.1Be sure to clean the sensors before executing the item.Procedure1) Select the item, and press the OK key.2) See that the adjustment ends automatically.BLT-CLN * Use it to clean the separation belt of the ADF.11) Select the time, and press the OK key.2) See that the separation belt goes on. Press the Stop key to stop the operation.REG-CLN * Use it to clean the registration roller of the ADF.11) Select the item, and press the OK key.2) See that the registration roller rotates. Press the Stop key to stop the operation.MTR-CHK ** Use it to check the ADF motor on its own.11) Select the item.2) Type in the number of a specific part using the keypad.3) Press the OK key.4) Press MTR-ON to check the operation.No. and Part0: pickup motor1: transport motorTRY-A4 ** Use it to execute auto adjustment on paper width detection reference point 1 for the original pickup tray of the ADF. (A4) 1TRY-A5R ** Use it to execute auto adjustment on paper width detection reference point 2 for the original pickup tray of the ADF. (A5R) 1TRY-LTR ** Use it to execute auto adjustment on paper width detection reference point 1 for the original pickup tray of the ADF. (LTR) 1TRY-LTRR**Use it to execute auto adjustment on paper width detection reference point 2 for the original pickup tray of the ADF. (LTRR) 1FEED-CHK**Use it to check paper passage for the ADF on its own.11) Select the item.2) Type in the number of a specific paper passage mode using the keypad.3) Press the OK key.4) Press FEED-ON to check the operation.No. and Paper Passage Mode0: simplexing pickup delivery operation1: duplexing pickup delivery operation2: simplexing pickup delivery operation w/ stamp3: duplexing pickup delivery operation w/ stampCL-CHK ** Use it to check the ADF clutch on its own.11) Select the item2) Type in the number of a specific part using the keypad.3) Press the OK key.4) Press CL-ON to check the operation.No. and Part0: pickup clutchCL-ON ** Use it to start the operation of the clutch.11) Select the item, and press the OK to start the operation of the clutch.2) Press the OK key to stop the operation. (It will stop automatically in about 2 sec. But the indication will not change to 'STOP' untilthe OK key is pressed once again.)FAN-CHK ** Use it to check the operation of the clutch on its own.11) Select the item.2) Type in the number of a specific part using the keypad.3) Press the OK key.4) Press FAN-ON to check the operation.No. and Part0, 1: cooling fanFAN-ON ** Use it to start fan operation.11) Select the item, and press the OK key to start fan operation.2) Press the OK key to stop the operation. (The operation will stop automatically in about 5 sec, but the indication will not change to'STOP' until the OK key is pressed once again.)
|
