Chapter 88-38F-8-663) Remove the screw [1], and detach the stack eliminator [2].4) Remove the 2 screws [3], and detach the pickup assembly sensor base [4].F-8-675) Disconnect the connector [1] (1 pc. each), and free the claw; then, detachthe right deck feed sensor [2] and the right deck pickup sensor [3].F-8-68When removing the scanner sensor, be sure to remove the paint used to lockthe claw in place in advance to prevent breaking the claw. When mountingit, be sure the claw is not displaced or the sensor is not disoriented.8.11.7 Manual Tray Assembly8.11.7.1 Removing the Manual Feeder Tray Unit 0010-8989iR7105 / iR7095 / iR70861) Open the manual feeder tray cover.2) Remove the door tape [1].- 1 screw [2]3) Remove the connector cover [3].- 1 screw [4]F-8-694) Disconnect the connector [1], and free the cable from the plate of the hostmachine (fixed in place using a cable clamp).F-8-705) Remove the stopper plate [1].- 1 screw [2]F-8-716) Remove the manual feeder tray unit [1] in the direction of the arrow.F-8-728.11.7.2 Fitting the Side Guide Timing Belt for the ManualFeed Tray Assembly 0010-8990iR7105 / iR7095 / iR7086Butt the rack plate [1] of the manual feed tray against section A (open state).Move the slide volume [2] in the direction of B, and fit the timing belt [3] tothe pulley [4].[1][4][3][1][2][3][2][3][1][1][2][3][4][1][1][2][1]
