Chapter 88-40F-8-79- The rear pickup roller is identified by its gold collar.When mounting the pickup roller [3] to the pickup assembly, be sure thatthe round marking [4] on the side of the roller and the round marking [5]on its collar (gold) are toward the machine's rear.F-8-808.11.10 Manual Feed Roller8.11.10.1 Removing the Feeding Roller 0010-8994iR7105 / iR7095 / iR70861) Remove the pickup roller, and remove the stop ring.2) Remove the two screws [1], and detach the manual feed tray guide [2].F-8-813) Remove the stop ring [3] from the front of the feeding roller assembly, andmove the feeding roller assembly [5] together with the timing belt [4] todetach.F-8-828.11.10.2 Orientation of the Feeding Roller 0010-8998iR7105 / iR7095 / iR7086When mounting the feeding roller [6] to the manual feed tray pickup assem-bly, be sure that the belt pulley [7] and the round marking [8] are toward themachine's front.F-8-838.11.10.3 Removing the multiple curling prevention roller0010-8999iR7105 / iR7095 / iR70861) Open the manual feeder tray cover and the upper right cover.2) Remove the manual feeder tray unit.3) Remove the manual feeder pull-off roller unit.4) Remove the rear upper right cover.5) Remove the hopper upper cover.6) Remove the hopper right cover.7) Remove the right inside front cover [1].- 2 screws [2]F-8-848) Remove the rail base (front) [1].- 2 screws [2]F-8-859) Remove the screw [2], and detach the rear fixing plate [1]; then, detach therear fixing plate [3].F-8-8610) Remove the following at the front and the rear: E-ring [1], space [2],bearing [3]. Then, detach the multifeeder curl-removing roller [4].[1][2]Direction ofrotationCollar (silver) front ofthe machineDirection ofrotationCollar (gold)[3][4][5]rear ofthe machine[1][2][1][5] [4] [3]55front of themachine[8][6][7][1][2][1][2][1] [2][3]
