Chapter 1313-4Points to Note When Cleaning/Replacing the Charging Wire or Replacing the Charging Wire CleanerAfter the following, check to make sure that the charging wire is in the middle of the charging wire cleaner; failure to observe this is likely to cause image faults:a. cleaning the charging wireb. replacing the charging wirec. moving the charging wire cleaner by handd. replacing the charging wire cleanerF-13-1F-13-2T-13-4CorrectWrongNo. Step Work Remarks5 Clean the optical assembly:- No. 1/2/3 mirror- dust-blocking glass- scanning lamp reflecting plate- standard white plateUse a blower brush. If dirt resistsremoval, use alcohol.6 Check the optical system:- scanner cable- scanner railCheck the area around the cable.Clean the sliding area, and apply silicone oil (FY9-6011).Check the scanner cable only at thefirst 250,000 prints.7 Dispose of the waste toner, and check the case. If the case is half full with waste toner, dispose of thewaste toner in a vinyl bag. Or, replace the case itself.8 Clean the filters.- ozone filter- dust filterRemove the dust from the filtersurface.9 Clean the developing assembly.- developing assembly rollClean the developing assembly roll.10 Clean the pickup /transport assembly.- transfer guide (upper, lower) plate- registration roller (upper, lower)- transport belt- transport rollers- scanner sensor (prism)Use an air blower, or dry wipe. (Donot use solvent.)
