6-49Printing Environment Settings6SETUP Menu Settings■ SPOOLEROFF*, ONSpecifies whether the printer should use the Spooler function.NOTE• For more details on the Spooler function, see "Chapter 2 Common NetworkSettings" in Network Guide.• This item is displayed only when NETWORK in the I/F CONNECTION options isset to ON, an optional hard disk is installed, and HARD DISK is set to ON.■ START WAIT TIME0 to 300 seconds; 0 seconds*Specifies the time interval from when the printer is turned ON to when the protocolstarts.NOTE• For more details on startup waiting time, see "Chapter 2 Common NetworkSettings" in Network Guide.• This item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.■ REMOTE UI SET.REMOTE UI ..........................ON*, OFFSSL*1 ....................................OFF*, ON*1 SSL is displayed only when an optional hard disk is installed, and HARD DISK is set to ON.Specifies whether the printer should use the Remote UI.NOTE• For more details on SSL, see "Chapter 2 Common Network Settings" in NetworkGuide.• This item is displayed only when NETWORK in the I/F CONNECTION options isset to ON.■ ETHERNET DRIVERAUTO DETECT.....................ON*, OFFCOMM.MODE*1 ....................HALF DUPLEX*, FULL DUPLEXETHERNET TYPE*1 .............10 BASE-T*, 100 BASE-TXMAC ADDRESS....................(Display only)*1 COMM.MODE and ETHERNET TYPE are displayed only when AUTO DETECT is set to OFF.Configures the Ethernet driver.
