6-31Printing Environment Settings6SETUP Menu SettingsLAYOUT MENU OptionsCOPIES1 to 9999; 1*Specifies the number of copies to be printed.The printer prints the specified number of copies.OFFSET Y/OFFSET X-50.0 to 50.0; 0.0* (mm)Adjusts the printing position in the vertical direction (Y) or the horizontal direction(X) by the specified value.The printing position changes as follows according to the increase and decreaseof the specified value.OFFSET Y: As the value increases, the gutter width in the Y directionincreases.As the value decreases, the gutter width in the Y directiondecreases.OFFSET X: As the value increases, the gutter width in the X directionincreases.As the value decreases, the gutter width in the X directiondecreases.IMPORTANTIf any part of the print image lies outside the printable area after adjusting theprinting position, the part will be missing in the print result.NOTEEach time you press [ ], the value increases in 0.5 mm increments, and eachtime you press [ ], the value decreases in 0.5 mm increments. If you keepholding down [ ] or [ ], the speed of the value changing is increased.YXDEFABCABCRange adjusted by "OFFSET X"Front Back Front+ directionBackYXDEFRange adjustedby "OFFSET Y"Adjust usingOFFSET Xand OFFSET Y+ directionOriginal margin
