3-17Canceling a JobUsing the Printer3Canceling All the Jobs (Hard Reset)When you want to delete all the jobs and data sent to memory for some reason,perform HARD RESET using the following procedure. A hard reset deletes the printdata received by all the interfaces, the job being processed, and the print data inthe printer memory.IMPORTANT• If the printer is reset while it is receiving data, the data that has not yet been sent to thememory will be sent after the reset. However, the data may not be printed properly.• The data that has been already sent to the memory are all deleted even if it is the data ofother interface. If you are using the printer on a network, be careful so that this operationdoes not affect the data from other computers when performing this procedure.1 Press the (Reset) key.The RESET menu is displayed.2 Select SOFT RESET using [ ] and [ ].3 Hold down [OK] until HARD RESET is displayed, then releasethe button.Hold down the button (approximately 3 seconds) until HARD RESET is displayed.Holding down the button less than 3 seconds is the operation for SOFT RESET.When <03 HARD RESET> disappears, the hard reset is completed.SOFT RESET →RESET →SOFT RESET →SOFT RESETHARD RESET03 HARD RESET
